Monday, April 22, 2013

How to Hang Pre-hung Door - Part 4 of 15 - Door Threshold Removal

Impact driver 
on stuck screw
By Gary Boutin

Supplies and Tools:
Hammer
Heavy leather gloves 
Impact screwdriver
Phillips bit
Phillips metal screws 1-1/2 inch

Mr. Victor Longpont hired my repair services to remove his garage door threshold plate.

This post shows the removal a threshold plate.

Step 1: An impact driver is a spring-loaded mechanism that moves a wedge and cam built inside it.
Please click here to continue this post.
Fig.1 Manual impact driver

 How to Hang a Pre-hung Door:


  • Part 1 of 15 Introduction - Why Replace This Garage Door
  • Part 2 of 15 Removing The Damaged Door
  • Part 3 of 15 Door Hardware Removed
  • Part 4 of 15 Door Threshold Removal
  • Part 5 of 15 Installing Door
  • Part 6 of 15 Recycled Metal Removed
  • Part 7 of 15 Caulking Outside Door Edges
  • Part 8 of 15 New Door Hardware Installed
  • Part 9 of 15 Caulking Door Screws Holes
  • Part 10 of 15 Inside Door Mud
  • Part 11 of 15 Inside Door Taping
  • Part 12 of 15 Inside Door Painted
  • Part 13 of 15 Applying Stucco To Door Edge
  • Part 14 of 15 Exterior Door Molding
  • Part 15 of 15 Old Door Cut to Trash


  • Update: DIY Advisor has New blogs check them today:

    • Cookie Alert: European Union laws requires that you know that this blog uses cookies. If you are concerned about this please click here to see how Google uses this information.

    Note: The DIY Advisor assumes no liability for omissions, errors or the outcome of any jobs. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed contractor if in doubt about any steps on these posts. All names were changed to protect client's privacy. DIY Advisor. Reproduction of site content including photos without permission prohibited. All rights reserved. © Copyright 2011-

    No comments:

    Post a Comment