Tuesday, May 21, 2013

How to Hang Pre-hung Door - Part 15 of 15 - Old Door Cut to Trash

Fig.1 Dewalt® Cordless saw
By Gary Boutin

Supplies and Tools:
Cordless saw
Carpenter pencil  
Dewalt® Cordless radial saw
Measuring tape

Mr. Victor Longpont hired my services to remove his garage door that had become damaged after a bad rain storm. The door had not been painted for over 30 years, the bottom of the door was damaged by a badly worn door sweep that allowed water into the bottom of the door. 

This post shows the three steps on how easy it is to cut a door with a cordless saw.

Step 1: Fig.1 is a Dewalt® 18-Volt 6-1/2 inch cordless circular saw. 
Step 2: Fig.2 shows the handyman preparing to cut the damaged door. Use a carpenter pencil and a measuring tape to mark the door cuts. The cuts needs to be the size of the trash can or smaller. Its easier to follow a line than to just pull the saw down the door and its good practice.
Fig.2 Cutting the door
Step 3: Fig.3 shows that once the lines have been drawn, use the saw to cut the door. Follow the lines on the door. Let each piece drop to the cement for later disposal.

Fig.3 Side view
Step 4: Fig.4 shows the door is in the trash can.
Fig.4 In trash

How to Hang a Pre-hung Door:


  • Part 1 of 15 Introduction Why Replace This Garage Door
  • Part 2 of 15 Removing The Damaged Door
  • Part 3 of 15 Door Hardware Removed
  • Part 4 of 15 Door Threshold Removal
  • Part 5 of 15 Installing Door
  • Part 6 of 15 Recycled Metal Removed
  • Part 7 of 15 Caulking Outside Door Edges
  • Part 8 of 15 New Door Hardware Installed
  • Part 9 of 15 Caulking Door Screws Holes
  • Part 10 of 15 Inside Door Mud
  • Part 11 of 15 Inside Door Taping
  • Part 12 of 15 Inside Door Painted
  • Part 13 of 15 Applying Stucco To Door Edge
  • Part 14 of 15 Exterior Door Molding
  • Part 15 of 15 Old Door Cut to Trash


  • Update: DIY Advisor has New blogs check them today:

    • Cookie Alert: European Union laws requires that you know that this blog uses cookies. If you are concerned about this please click here to see how Google uses this information.

    Note: The DIY Advisor assumes no liability for omissions, errors or the outcome of any jobs. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed contractor if in doubt about any steps on these posts. All names were changed to protect client's privacy. DIY Advisor. Reproduction of site content including photos without permission prohibited. All rights reserved. © Copyright 2011-

    No comments:

    Post a Comment