Tuesday, January 5, 2016

How to Create and Install Xenon Pucks into a Bedroom Light Tier - Part 8 of 8 - Fine Tuning

Fig.1 Ryobi Drill
By Gary Boutin 

Supplies and Tools:
#8 Wood screws 
18-Volt Ryobi Cordless Phillip Screwdriver

In 1991 we received a bed set with a light tier over the bed. It had side drawers tiers tall enough to hold over the mirror a bridge that housed 3-incandescent lights that could be dimmable from a switch within the headboard. Theses posts shows my solution. 
This is the final post of this series that shows how to use an existing lamp parts and the installation of the
Commercial Electric® Xenon puck light to an aging wood tier.

Step 1: Fig.1 above right shows that two lights are operational.
Step 2: Fig.2 show the a close up of what the lamp looks like when installed on the wooden tier.

Step 3: Fig.3 shows the job is finished. All three lamps are installed and working.

How to Create and Install Xenon Pucks into a Bedroom Light Tier:

Update: DIY Advisor has New blogs check them today:

  • Cookie Alert: European Union laws requires that you know that this blog uses cookies. If you are concerned about this please click here to see how Google uses this information.

Note: The DIY Advisor assumes no liability for omissions, errors or the outcome of any jobs. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed contractor if in doubt about any steps on these posts. All names were changed to protect client's privacy. DIY Advisor. Reproduction of site content including photos without permission prohibited. All rights reserved. © Copyright 2011-

No comments:

Post a Comment