Sunday, January 22, 2012

How to Repair Emergency Bathroom Sink ABS Drain Pipes

Fig.1 - Wall pipe damage
By Gary Boutin

Supplies and Tools: 
Union, non-threaded, 1 1/2-Inches
ABS cement
Hack saw
Portable hack saw
Sandpaper or emery cloth
Sink basket brass tail pipe
Pipe dope

This job was done on an emergency basis in Chino Hills, California. Inez had a friend replace some fluorescent tubes in her master bathroom ceiling lamp. The lights were at the far end of the room and the bath vanity was quite large. Inez's friend stepped on the vanity to get a better footing and the vanity fell of the wall and its pedestal. When the vanity fell, the sink separated from the top and sheared off the ABS drain pipes making it impossible to drain correctly.

This post show the ten steps on how to solve and repair this problem. 

Step 1: Above right fig.1 shows the damage to the sink tailpipe and fig.2 below shows the ABS pipe
that was damaged.
Fig.2 Sink 
tailpipe damaged
Step 2: Fig.3 shows the sink had been moved to its correct location, and only the drain line needed to be repaired. My first step was to check the existing pipe, it did not appear to be damaged. A 1-1/2 inch union was dry tested on the pipe without cement. After the fit was true, sand both the pipes and the union the pipe was pushed together.The blue cement on the inside of the drain pipe.
Fig.3 ABS 
drain pipe
Step 3: Fig.4 shows the next step was to cut the existing wall P-trap attached to the bad union. Use a hack saw to separate the existing union from the P-extension trap.
Fig.4 Cut off ABS pipe
Step 4: Fig.5 shows the ABS cement was applied to the outside of the pipe and the inside of the union.
Fig.5 ABS Glue
Step 5: Fig.6 shows the union in place and ready to accept the P-extended pipe.
Fig.6 Drain pipe
Step 6: Fig.7 shows the insertion of the brass tail pipe
into the P-trap. Take the new sink basin brass tail pipe and measure the P-trap to see if its in the right area.
Fig.7 Brass 
pipe adjustment
Step 7: Fig.8 shows the application of pipe dope on the threads of the sink basin tail pipe and thread upwards into the brass pipe near the sink basin.
Fig.8 Pipe Dope
Step 8: Fig.9 notice the brass tail pipe.
Fig.9
Brass tail pipe
Step 9: Fig.10 shows the completed P-trap.
Fig.10 P-Trap
Step 10: Fig.11 shows the water leak test. Check for leaks and make certain all works fine. At the end the client was happy to use her sink again.
Fig.11 Job done

DIY Advisor Blogs:
  • Handyman Blog: DIY Advisor
  • Food Blog: From Gary Boutin
  • Artwork Blog: Light in Dark Artwork
  • Class-A Tests: DIY Class-A Drivers License Tests

    • Cookie Alert: European Union laws requires that you know that this blog uses cookies. If you are concerned about this please click here to see how Google uses this information.

    Note: The DIY Advisor assumes no liability for omissions, errors or the outcome of any jobs. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed contractor if in doubt about any steps on these posts. All names were changed to protect client's privacy. DIY Advisor. Reproduction of site content including photos without permission prohibited. All rights reserved. © Copyright 2011-

    1 comment:

    1. Nice Blog!! Great Post !! Like your Blog and your ideas and i think its benificial for us and i keep to visit your blog regularly because i got lot of information through you blog

      ReplyDelete