|Fig.1 Messy hose|
Supplies and Tools:
Hose brass connector kit (brass nipple connector and hose clamp)
Snob nose flat screwdriver
This post shows the five steps to repair a damaged hose.
Step 1: Above fig.1 shows the hose is a mess. Straighten the hose to find the problem.
Step 2: Fig.2 shows the hose to see if there were other leaks and there was no leaks and the water came out of the hose like it was designed.
|Fig.2 Damaged |
|Fig.3 cut damage end|
|Fig.4 Tightened stainless |
|Fig.5 Hose repaired|
Step 1. Cut hose.
Step 2. Thread the clamp onto the hose.
Step 3. Thread the brass nipple into the hose.
Step 4. Tighten the hose clamp around the brass nipple.
Step 5. Push down the end of the hose clamp and/or place tape around the hose clamp to prevent injury.
Update: DIY Advisor has New blogs check them today:
- Handyman Blog: DIY Advisor
- DIY Advisor Sitemap
- Food Blog: From Kiwis To Pistachios
- Food Blog Sitemap
- Tool Blog: DIY Advisor Toolbox
- Tool Blog Sitemap
- Artwork Blog: Light in Dark Artwork
- Artwork Blog Sitemap
- Class-A Tests: DIY Class-A Drivers License Tests
- Class-A Tests Sitemap: Class-A Sitemap
- DIY Poem: DIY Poem Meter Blog
- DIY Poem Sitemap: DIY Poem Sitemap
Note: The DIY Advisor assumes no liability for omissions, errors or the outcome of any jobs. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed contractor if in doubt about any steps on these posts. All names were changed to protect client's privacy. DIY Advisor. Reproduction of site content including photos without permission prohibited. All rights reserved. © Copyright 2011-